E8400@4GHz su Rampage Formula

[Carneo]

Ho portato un E8400 a 4GHz su questa main impostando solo 445x9 ed il vcore a 1.425 (1.400 CPU-Z) ed il vNB a 1.43 (giusto perchè lasciandolo in auto me lo impostana a 1.58 con temperature sui 90°). Le ram sono delle G.Skill 2x2 DDR2 1000 queste:
Sito ufficiale
UFA
lasciate in auto.
Vorrei un consiglio sui vari voltaggi da fissare per non lasciarli in auto e magari sulle impostazioni del FSB, delle RAM, e del PL in modo da ottenere le migliori prestazioni...

Ai Overclock Tuner:
Oc from cpu level up:
Cpu Ratio setting:
FSB Strap to North bridge:
FSB frequency:
PCIE frequency:

Dram Frequency:
Dram Command Rate:
DRAM CMD Skew on channel A
DRAM CMD Skew on channel B
DRAM CLK Skew on channel A
DRAM CLK Skew on channel B
Dram timing control:

Dram Static Read control:
Ai Clock Twister:
Ai Transaction Booster:

Cpu voltage:
CPU PLL Voltage:
North Bridge voltage:
Dram Voltage:
FSB Termination Voltage:
South Bridge voltage:
South Bridge 1.5v:
Load Line Calibration:
CPU GTLVref:
NB GTLVref:
DRAM Controller Voltag REF:
DRAM Channel A Voltage REF:
DRAM Channel b VoltageREF:

CPU LED Selection
NB LED Selection
SB LED Selection
Voltiminder LED

CPU Spread Spectrum:
PCIE Spread Spectrum:



P.S. Timing:

Cas Latency:
Ras to Cas Delay:
Ras pre Time:
Ras Act Time:
Ras to Ras Delay:
Ref Cycle Time:
Write Recovery Time
Read to Pre Time:

Read to Write Delay (SD):
Write to Read Delay(S):
Write to Read Delay(D):
Read to Read Delay (S):
Read to Read Delay (D):
Write to Write Delay(S):
Write to Write Delay(D):
Write to Pre Delay:
Read to Pre Delay:
Pre to Pre Delay:
All Pre to Act Delay:
All Pre to REF Delay: