salve,
la mia configurazione:
ETH0 WAN TIM LINA FTTC 1
ETH2 WAN TIM LINE FTTC 2
ETH4 LAN
ho la necessita' di aprire una porta (1114) sulle 2 interfaccie WAN verso l'interfaccia LAN ip 192.168.0.22
Printable View
salve,
la mia configurazione:
ETH0 WAN TIM LINA FTTC 1
ETH2 WAN TIM LINE FTTC 2
ETH4 LAN
ho la necessita' di aprire una porta (1114) sulle 2 interfaccie WAN verso l'interfaccia LAN ip 192.168.0.22
Non ho (più) un setup dual-wan quindi non posso verificare con precisione ma il "Port forwarding" da GUI web non prevede l'indicazione della WAN, solo quale porta/protocollo e la destinazione (Firewall/NAT -> Port Forwarding -> Port forwarding rules -> Add Rule).
Non ti funziona?
(Ovviamente però la porta deve essere aperta per entrambe le interfacce WAN nel firewall, non è sufficiente il "Port Forwarding").
ho trovato questa guida ma serve dichiarare la wan pensi che vada bene lo stesso?
configure
set port-forward auto-firewall enable
set port-forward hairpin-nat enable
set port-forward wan-interface eth0
set port-forward lan-interface eth1
set port-forward rule 1 description https
set port-forward rule 1 forward-to address 192.168.1.10
set port-forward rule 1 forward-to port 443
set port-forward rule 1 original-port 443
set port-forward rule 1 protocol tcp
commit ; save
aggiornamento se seleziono una wan alla volta funziona altrimenti no
WAN interface
In questa conf stai impostando la WAN come eth1.
Non so se la conf dual-wan preveda un settaggio diverso in questa fase.
Questa è la parte che invece riguarda il solo port-forward. Se provi ad applicare solo questa parte (quindi aggiungendo "configure" e poi "commit; save" senza la parte che modifica la WAN ti funziona?
Altrimenti dovresti fare un export della configurazione con il dual-wan funzionante che provo a vedere se riesco a capire come si comporta.