Ciao Siscoregna e ciao Giampa (mio guru), allora fatemi capire, tutti a spiegarmi che il vcore e vdra son troppo alti....ma io se li abbasso il pc mi fa schermata blu quando riavvio.....
NON PER RIPETERE MA VI RISCRIVO SOTTO IL TEMPLATE STABILE A 3.80Ghz ciao
Menù Extreme Tweaker e sotto menù ...
Ai Overclock Tuner : Manual
OC From CPU level Up : Auto
OC From Memory level Up : Auto
CPU Ratio Settings : 19
Nel Menù CPU Configuration :
CPU Ratio Setting : 19
C1E Support : Disable
Hardware Prefetcher : Enable
Adjacent Cache Line Prefetch : Enable
Intel Virtualization Tech : Disable
CPU TM Function : Disable
Execute Disable Bit : Disable
Intel HT Technology : Enable
Active Processor Cores : ALL
A20M : Disable
Intel C-State Tech : Disable
BCLK Frequency : 200
PCI-E Frequency : 101
Dram Frequency : 1600
UCLK Frequency : 3200
QPI Frequency : Auto
Nel menù DRAM Timing Control : tutto su AUTO meno i parametri sotto elencati
DRAM Cas Latency : 9
DRAm Ras to Cas Delay : 9
DRAM Ras PRE Time : 9
DRAM Ras ACT Time : 27
DRAM Timing Mode : 1N
EPU II Phase Control: Full Phase
Load-Line Calibration: Enable
CPU Differential Amplitude:800mV
Extreme OV: Disable
CPU Voltage: 1.30v
CPU Pll Voltage: Auto
QPI/DRAM Core Voltage: Auto
IOH Voltage:Auto
IOH PCIE Voltage:Auto
ICH Voltage:Auto
ICH PCIE Voltage: Auto
DRAM Bus Voltage: 1.65v
CPU Spread Spectrum: Disabled
PCIE Spread Spectrum: Disabled
CPU Clock Skew: Auto
IOH Clock Skew: Auto
__________________
Rispondi quotando
