Vcore mod Kt3 Ultra 2

[john_petrucci]

Salve
Ho trovato questo testo.....allego anche l'immagine del chip....
Ali te l'avevi eseguita così???

For both of these mods you can use either an 18k resistor or a 50k pot. Although the pot allows more adjustments I prefer the more consistent voltage that you get with a resistor. EITHER works fine. For playing around and/or a temporary setup then I suggest a potentiometer. If you are looking for a more permanent setup then I would use a resistor.

For the first mod solder a wire to one side of your resistor or pot and the other side to pin 7 of the HIP6302. That little indentation that you see indicates pin 1. Use the diagram of the chip above to help guide you to which pin needs to be connected. Then connect one end of another wire to the other end of the resistor and then the other end to a ground. I prefer using the ground on the IC chip itself which is pin 9.

Ora devo procurarmi una resistenza da 18k e un saldatore a punta......ho visto il chip sulla scheda madre è piccolino